Theses/Dissertations from 2007
Ground Heat Exchangers: Analytical and Numerical Modeling and Experimental Validation, Gopal K. Bandyopadhyay
Performance evaluation and emissions characterization of biojet fuels derived from soybean oil and its derivatives in a gas turbine, Prasad S. Chavan
The effects of fuel-to-oxygen stoichiometry and temperature on coal ash fine-fragmentation mode formation mechanisms, Gregory George Fix
The effect of water on the acidity of sulfated zirconia, Anil Kumar Gyanani
Testing of lithium silicate and hydrotalcite as sorbents for CO₂ removal from coal gasification, Mohammed Allabaksh M Hussain
Electricity Sector Reform And Its Environmental Implications, Shankar Kumar Karki
An equilibrium model to predict carbon deposition in a thermally integrated biomass gasifier -- solid oxide fuel cell power generation system, Christopher M. Kinchin
Understanding the effect of wood swellng on the failure of epoxy/wood bond under wet conditions, Dharmender Kumar
The characterization of cracked crop oils and development of acrylic polymers from crop oils, Lu Zhang
Theses/Dissertations from 2006
Determination of key parameters affecting titanium dioxide activity, carryover, and attrition in a fluidized bed photo reactor, Christopher Lee Flakker
Filter fabric coating method to facilitate mercury emissions abatement, Carol A. Horabik
The commercial feasibility of a process plant to produce biojet fuel from soybean or canola oil, Marko Jukić
Improving the mechanical and degradation properties of poly (L-lactide) by copolymerization with poly (vinyl pyrrolidone) macroinitiators, Suman Sannigrahi
Size resolved characteristic comparison of Dekati and Berner low pressure impactors, Chunmei Wang
PLA-Graft-PE copolymers to resist higher impact stress, Hongbo Wang
Theses/Dissertations from 2005
A novel transient reaction method for catalytic reactions, Jesse Allan Ahlers
Cold flow biojet fuel from soybean oil, Irshad Ahmed
Synthesis and characterization of poly (L-lactide)-poly (D, L-lactide) stereo-block copolymers, Sachit Chopra
Development of an automatic instrument for rapid analysis of selenium in food grains, Sathyendra K. Ghantasala
Swelling stress and strain analysis of untreated, acetylated, and HMR treated southern yellow pine, Blake M. Hofferber
Diffusion and remediation of organic chemicals in softwood, Nidhi Jalan
Sampling analysis of tar and particulate in the producer gas from downdraft gasifier, Srinivas Kolli
Effect of hydration on Brønsted acidity of solid acid catalysts, Apoorva Kulkarni
The effect of fuel size on the energy density of producer gas in a biomass-fired modified downdraft gasifier, Kyle Edgar Martin
Optimum photodeposition parameters for the production of Ag-TiO₂ and Ag-TiO₂-A1₂O₃ for photocatalytic oxidation applications, Stephanie J. Miksche
Remediation techniques for removal of 2,4-DNT from concrete & estimation of diffusion coefficient of n-hexadecane in concrete, Sachin Phutane
Tolerance of solid oxide fuel cells to tars, Devinder Singh
High temperature corrosion of potential heat exchange alloys under simulated coal combustion conditions, Joshua R. Strege
Characterization of refractory corrosion by flowing slag, Hong Xi
Mercury Oxidation by Chlorine-Containing Species and Scrubbing in a Wet Flue Gas Desulfurization System, Yongxin Zhao
Theses/Dissertations from 2004
Electro-Thermal Model for a Solid Oxide Fuel Cell, Eduardo Hernandez-Pacheco
Coal mercury chemistry and its implications for the development of a two-step acid wash coal cleaning method for mercury emissions abatement, April E. Hoffart
Development of remotely operated student laboratory experiments, Corwin S. Kanning
Characterization of hot gas filter ash strength development during hot gas filtration, Biplab Mukherjee
Photocatalytic oxidation of methanol in a fluidized bed applicaton, Ryan James Nelson
Model for prediction of strength of ash deposits, Dhananjay Sakrikar
Exploring the feasibility of removal of hydrogen sulfide from gaseous streams by anaerobic photosynthetic bacteria, Pushkaraj Sardesai
Theses/Dissertations from 2003
Prediction of the distribution of volatile sodium species during combustion and cooling in the coal-fired boilers, Muḥammad Amānullāh
Active sites and the effects of water and temperature on the photocatalytic oxidation of formic acid and acetic acid on TiO₂ catalyst, Michael John Backes
A comparative assessment of acid wash and bioleaching pretreatment options to remove mercury from coal, Laura C. Dronen
Photocatalysis as a precursor to biofiltration for oxidation of organics, Benjamin John Goebel
Transient photocatalytic oxidation study of organics on titanium dioxide using mass spectrometry and fourier transform infrared spectroscopy, Adrienne Claire Lukaski
Theses/Dissertations from 2001
Char Reaction Kinetics in a Transport Gasifier, Jason P. Jacobsen
Kinetic Modeling of a Transport Coal Gasifier, Ryan Zebadiah Knutson
Two-phase flow models for low-pressure systems, Kerryanne M. B Leroux
Determination of baseline response data on the Energy and Environmental Research Center wet scrubber system, Jeremie M. Moberg
Theses/Dissertations from 2000
Removal of zinc and nickel by Cladophora parriaudii, Charles K. Adou
Activated Carbon Injection for Mercury Control in Coal-Fired Boilers, Randy Ray Brintnell
Photocatalytic oxidation of organics on sulfated TiO₂, Lefei Ding
Electrostatically enhanced barrier filter collection, Nathan J. Kadrmas
Predicting slag viscosity from coal ash composition, Jason D. Laumb
Trichloroethylene mixture effetcs [i.e. effects] during transient photocatalytic oxidation of methanol, Lucas R. Schmidt
Estimating left ventricular isovolumic pressure from ejecting pressure and/or aortic flow, Scott R. Zarr
Theses/Dissertations from 1999
Modeling two-phase flow behavior at near vacuum pressures, Charles Hawkinson
Analysis and modeling of cryogenic transfer line cool-down, A S. M Rokanuzzaman
Two-phase flow in a T-junction, Rajesh Yalamanchili
Theses/Dissertations from 1998
Cadmium removal using Cladophora in a flow reactor, Ryan Dorn
Enhanced compressive strength of high performance polymers through c[r]osslinking, Jodi Marie Gustafson
Analysis and modeling of cryogenic transfer line cool down, Kazi Ashraful Haque
Modeling a centrifugal membrane unit using computational fluid dynamics, Theodore Nathan Kestner
Experimental investigations of dispersion at permeability transitions in heterogeneous porous media, Dwayne K. Kolodka
Capture of alkali during pressurized fluidized-bed combustion using in-bed sorbents., Michael David Mann
In-situ bioremediation process for removal of lead and cadmium using Lemna minor, Gazi Nazmul Haq Rahmani
Benzene removal from gasoline using subcrit[i]cal water extraction, Lanny Jerome Schmidt
Theses/Dissertations from 1997
Statistical modeling of the recoil compressive failure of high-performance polymers, Tanim Ahmed
A mechanistic model of phase redistribution in wellbores, Nafiza Islam
Pressure transient analysis to locate and characterize blockages in pipelines, Dongqing Lin
Cadmium removal using living aquatic plants, Rumman Sobhan
Theses/Dissertations from 1996
Mechanistic model of multiphase heat and fluid flow in geothermal wells, Peter T. Argument
Process optimization of bench-scale packed-bed reactor for ethane hydrogenolysis, Syed M. Habibullah
Mercury Sorption on Metal Oxides, Heidi L. Hitchcock
Supported copper oxide and cobalt oxide catalysts for nitrous oxide decomposition, Ping Jin
Mechanistic modeling of a Lurgi Mark IV dry-slagging gasifier, Jonathan Kautz
Mass and energy transport on fractal lattices, Hai Ni
Analysis of the compressive and tensile properties of Kevlar fiber after thermal treatment, Fernanda Santos Philbrick
Development of a pneumatic spreading system for silicon carbide precursor tows, Allan A. Puzianowski
Performance comparisons of catalytic fabric via the reduction of NOx in a bench-scale SCR system, Todd Allen Svihovec
Theses/Dissertations from 1995
Mechanisms for the desulfurization of ethanethiol over molybdenum disulfide at moderate pressure, Stephen J. Brandt
Improving Aspen/SP Computer Model of Great Plains Coal Gasifiers, Md. Moazzem Hossain
A novel approach to surface modification on MoS₂ (0001) using hydrogen and hydrogen sulfide adsorption, Todd L. Peterson
Experimental development of the BET and Keller model adsorption isotherms, Lisa M. Sperle
Theses/Dissertations from 1994
Supported rhodium and copper catalysts for nitrous oxide reduction from model fluidized bed coal combustor exhaust streams, Todd W. Dann
The characterization and preparation of single crystal molybdenum disulfide as a model catalyst, Susan L. Peterson
Gasifier modeling using neural networks, C Narahari Rao
Void Fraction and Pressure Drop in Annular Two-Phase Flow, Danping Si
Artificial intelligence as it applies to industrial process control, Robert G. Strain
Theses/Dissertations from 1993
A Unified Model for Multi-Phase Flow and Heat Transfer in Wellbores, Mohammad Mahbubul Ameen
Optimization of Great Plains Coal Gasification Using Aspen/SP, Bradley C. Carpenter
Treatability testing of a coal-processing wastewater using an anaerobic, granular activated carbon treatment system, Rose H. Fraley
Coal Water Slurry Combustion in a Simulated Diesel Engine Cylinder, Allan Robert Holmes
Theses/Dissertations from 1991
Rheological characterization of coal water fuel slurries, Syed Farid Ahmed
Advanced control of a distillation column using artificial intelligence, David Scott Heisler
Vapor-Liquid Equilibrium of Hydro-Treated Anthracene Oil (HAO61), Michael J. Holmes
Two-phase flow simulator for a geothermal well, Ka Leung Lok
The use of magnetite as a catalyst for the chemical vapor deposition of carbon on carbon fibers, Richard E. Zielinski
Theses/Dissertations from 1990
The Fate of Flame Volatized Sodium During the Combustion of Pulverized Coal in Reaction With Silica and Sulfur (Studied with the Aid of a Synthetic Coal), Thomas A. Erickson
The fractal analysis of catalytic glass fabrics, Timothy Palmer Moberg
The effects of catalyst and treatment temperature on the surface area of three coals as determined by the BET and Dubinin-Radushkevich models, Jeffrey L. Sobolik
Theses/Dissertations from 1988
Multiphase Flow in Vertical and Inclined Annuli, Rajeev Patel
Theses/Dissertations from 1987
Study of Char Particle Combustion Using Thermogravimetric Analysis, Mihir Manookumar Patel